MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG Midget and Sprite Technical - Flexible exhaust and exhaust hangers

Hi folks,

You may have seen from a few other threads that my car is undergoing an exhaust upgrade programme!

Part of this involves putting a flexible section between the collector and the exhaust to make connecting everything up easier and also to protect the manifold in the event of exhaust grounding.

Do you think I should put another exhaust hanger in, perhaps somewhere in the region under the seat/gearbox, to support the weight of the exhaust? Rather than have it "dangle" off the flexi section.

Arie, you about?!

http://www.mg-cars.net/mg-midget-sprite-technical-bbs/witch-tubular-manifold-2010101119102130030.htm

Cheers,
Malcolm
Malcolm Le Chevalier

sounds like a great idea
R W Bowers

Malcolm

I have just fitted a Maniflow straight through single box and would concur that the more support the better. The back box on the Maniflow is quite heavy, and I opted to fit an additional hanger between box and manifold - as well as the hanger the other side of the box. I do recommend you also add some sort of bobbin as a rudimentary shock absorber - as per all other mounts.
Mark O

OK, cool, too easy!

I have a spare bobbin somewhere, just need an appropriate type P-clip type thing.

Cheers,
Malcolm
Malcolm Le Chevalier

I got to SUPPORT that idea... hang it up there

prop
Prop and the Blackhole Midget

Malcolm, can;t remember which model you have but if an A series you should have a bracket from the bottom of the bellhousing across to the exhaust which will support it adequately if correctly fitted.
Parts 32,33,39 etc
http://www.moss-europe.co.uk/shop-by-model/mg/midget/exhaust/exhaust-systems/exhaust-system-1275-1500cc.html
David Smith

I did not know that David, thanks. it is a 1500, where the exhaust hangs off the manifold, then isn't supported until the axle.

if it works on the 1275 it must be a good idea!
Malcolm Le Chevalier

I've had problems with the quality of the rear rubber exhaust mounts - rectangular rubber with plates bonded - the ones fixed to an angled plate bolted to the boot floor - GEX7155, they are used on 1275 and 1500 'across the back' systems.

I've had two delaminate - rubber to steel bonding failing on newish items.

Once again rubbish parts - I have made supplier aware.

R.
richard boobier

This thread was discussed between 25/02/2016 and 27/02/2016

MG Midget and Sprite Technical index

This thread is from the archives. Join the live MG Midget and Sprite Technical BBS now