Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG Midget and Sprite Technical - Where do bolts go for footwell dip switch?
Got the horn sorted, now I'm after a bit more help. I can't find the mounting holes for the light dip switch. When I got it painted bitumastic mat was laid in the footwell which has covered up the holes. I found the top bolt hole then swang it through and arc but I can't find the bottom bolt hole. From the front I can't see the hole either. Could someone please tell me where it should be. Thanks
|
| Greg H |
the front side
|
| Greg H |
| Are you just trying to mount the switch or do you have a mounting bracket? |
| Dave O'Neill2 |
| I have the mounting bracket and it's been on there before. Perhaps I just had a screw in the bottom and it's double skinned which is why I can't see the hole on the other side. I removed the carpet to do it and came back a few hours later to see a puddle of brake fluid on the floor. One more thing to fix. :(
|
| Greg H |
| Greg. You are correct, you can't see the lower hole from the front because it is a captive nut in the footwell stiffener. However, the lower hole is directly below the top one. Her's a pic of my '65 car which I don't think is different to yours. Sorry it's a bit blurred, I was a bit too close, but it should give you some idea of where to start. Bernie.
|
| b higginson |
| From your first pic, it looks like you were nearly there, but about 1/2" out. Bernie. |
| b higginson |
| Thanks Bernie very helpful! With a bit of proding I found it. Without your pic I think it would have taken me quite a long time because I really thought it laid over a bit. |
| Greg H |
This thread was discussed between 12/08/2012 and 13/08/2012
MG Midget and Sprite Technical index
This thread is from the archives. Join the live MG Midget and Sprite Technical BBS now