 
Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG Midget and Sprite Technical - wire wheel conversion
| im looking for a wire wheel conversion set for a sprite preferably in holland | 
| awe rijt | 
| which axle - quarter elliptic or half elliptic springs? | 
| David Smith | 
| I think it's quarter | 
| Gary & Gaps | 
| You might need to talk to Ton Blankespoor, he does 1/4 elliptic W/W axles. http://www.tonblankespoor.nl/ | 
| Dave O'Neill2 | 
| yes its a quarter elliptic car but.... are the bolt on adaptors any good? | 
| awe rijt | 
| and for gary , the original owner of your speedwell bonnet was tonio hilderbarnd (i bought it close to were the hildebrand garage was years ago) he was a well know racing driver in holland (and speedwell importer) did i send you the picture of the bonnet in the condition i found it? angelo | 
| awe rijt | 
| Imo are bolt on adapters crap! The track changes and loads the marginal wheelbearings a lot more. The short bolts holding them on are always a bit iffy to me. And with bolt on adapters it just does not look good. | 
| Onno K | 
| Hi Angelo, That's great to know. many thanks. | 
| Gary & Gaps | 
This thread was discussed between 05/02/2012 and 06/02/2012
MG Midget and Sprite Technical index
This thread is from the archives. Join the live MG Midget and Sprite Technical BBS now