Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
|
MG MGA - Brake Pads Dont Fit...
Have fitted new brake discs and brake pads and cannot now get the calipers into place, i.e the brake disc will not go into the gap between the pads Have tried removing the bleeders and using a C Clamp to make sure that the pistons are fully withdrawn, but pads appear to be too thick to even go on. Do you advise that I should sand the pads down, remove the non-judder coating on the inside or ...????? Thanks Aleks |
Aleks Stojanovic |
which supplier? |
Art Pearse |
MG Spares - the new discs are about 10mm wide and the gap between the pads is only 7mm. I cant see how I could withdraw the pistons any further as have used a C Clamp - although they are not flush - so maybe if there is another way of doing this more effectively.... |
Aleks Stojanovic |
If it helps my LH disc is 0.346" (8.79mm) thick. Also I have a spare set of old used Lockheed pads and the steel backing on these is 0.235" (5.97mm)thick . The thickness, including friction material, of the least worn in the set is 0.472" (11.99mm)......................Mike |
m.j. moore |
Mike, I checked and the manual says that the width of the disc should be 0.38" and should be changed if it goes below 0.33" - which is not much thinner than your LH disc. Still think that perhaps there has to be a better way of pushing the pistons in so that they are completely flush - better I mean than using a C Clamp... Aleks |
Aleks Stojanovic |
Aleks, I've always used a c-clamp to push mine in - I put a small piece of wood between the c-clamp and the piston so I can press it all the way in (both sides). You should have plenty of room. Gene |
Gene Gillam |
I believe the piston with dust seal in place should return to be flush with the caliper housing. If the piston is protruding after pushing it all the way in, then it is not all the way in, or it is the wrong piston. |
barneymg |
Aleks, I was giving you some dimensions so you could start the process of elimination. For example you may have been supplied with the wrong pads,etc. I can give you piston dimensions also as I have a spare pair.........................Mike PS With my current annual mileage I have enough metal on my discs to last 20 years or more!! |
m.j. moore |
Did you remove the master cylinder cap Graham |
Graham V |
Aleks, After converting my front brakes from drums to disks I had the same problem. Brand new rotors and pads. The pads were slightly too thick. I removed the anti-squeal pads (non-judder coating) and was able to install the brake pads. I have not had any issues with brake squeal. John |
John Backman |
Mintex pads and new Moss calipers - perfect fit Also Moss pads and old MGA calipers, same good fit. |
Art Pearse |
Your piston should retract to be flush. Me thinks you are not getting enough travel. Have you checked or renewed the seals on the pistons? |
Ian Pearl |
Open your bleeders a bit when you press the cups back in. Brian W. |
ZBMan |
This thread was discussed between 15/07/2015 and 29/07/2015
MG MGA index
This thread is from the archives. Join the live MG MGA BBS now