MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB GT V8 Factory Originals Technical - HEADERS FOR 3.8 GM.

Has anybody located a manufacturer for close fitting headers for GM 3.8 v-6 ?/
Sandy
Sandy Sanders

If you are refering to the "GM" 3.8 (3/4 of the 305 V8) Sanderson makes headers for this engine. If you are talking about the "Buick" 3.8, I do not know.
Mike Maloney

Sandy- Yes, Pacesetter. However, when you look at the performance and starter- roasting you get with the "huggers" I might recommend a more power-friendly set through the walls. Why? Cause I'm de man here. For 2 years, I've tried to identify those fools like me who did the 3.8 conversion. My 90* effort is in a 1979 LE and fits wonderfully. The hood closes with 1/2 to spare over the EFI, OBDII, 3800 spaghetti feed of the 2001 Camaro v6 with L460-E and shortened stock rear axle/pumbkin.Used to be about 6 of us, now I just can't find anyone.....except you. I have production notes on the set of headers I fabbed: six primaries at 34 inches, into a 2 x 10 collector, balance cross tube, dual FlowMasters ( offset 2 inches) then 1 3/4 pipes out. I moved the tank over 3 inches to get the second passenger side pipe between the leaf and tank. While it was out, I installed the Camaro stock fuel pump run by the stock PCM to provide the 45 pounds, and swirl pot reguired ( a drop in unit that protrudes into the spare hub area of boot). Only real problem was u-jointing the steering to get around a plug. Contact me off-board and I'll show you some jpegs of the homey-headers, completed with a home brewed jet hot coating good to 1200* ( or so says Cashell). Goodluck, Vic
vem myers

Vem,

I will be sending you out an email with a number of pics in a couple of minutes with a 1996 Camaro 3.8L V6 in a TR8. Really a nice conversion. I am assisting with wiring at this time. The TR7/8 is the perfect car for these motors. Maybe even the perfect cars for the 302 for length and width.

-BMC.
BMC Brian McCullough

Brian- Looks like enuf room to play poker in that bay. The 96 is usher of the Series II yes? Vic
vem myers

I believe its the same as yours in every way except the drive by wire.

-BMC.
BMC Brian McCullough

Yes Brian- An opportunity to swap stories here. The 1996 inaugurated "Series II" 3800 ran through 2001. This engine was voted "one of the 10 best V6 engines available" I just wish I knew of the SC feature which dominates talk groups: 245 hp before the chip is even approached for a tweakend. Vic
vem myers

any news from anyone on the 3.8 convert?
vem myers

This thread was discussed between 01/01/2007 and 12/01/2014

MG MGB GT V8 Factory Originals Technical index

This thread is from the archives. Join the live MG MGB GT V8 Factory Originals Technical BBS now