MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB Technical - Availability of repro aluminium engine tags?

Hello,

My 64 B ha an engine that is beatifully finished, but where the engine tag is gone, I guess after hot tanking in Hexagene or similar. Is there anyone out there reproducing these tags, and/or imprinting the engine number?

Thank you,

Jan
Jan Emil Kristoffersen

If you search the archives on the Midget General BBS, you should find the answer there.

There is a Mini specialist that does them, but I don't remember which one.
Dave O'Neill 2

Todd Clarke of "Clarke Spares and Restorations" does them.
I buy MGA parts from Todd. What he sells he either makes himself or commissions their remanufacture to original specs.
http://www.clarkespares.com/carparts.html
T Aczel

Jan, you can get a blank plate on ebay For £2.70

http://www.ebay.co.uk/itm/Classic-A-Series-Blank-Engine-Number-Plate-Plaque-Mini-MGA-MGB-/321764880579

You can also get it stamped with your engine number for £12.65

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=322147019045

Andy
Andy Robinson

http://www.retrominisltd.co.uk/index.php?main_page=index&cPath=31 but check the size.

http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=28976#13 for 18G-GK blanks

http://www.classic-plates.com/ maybe if you supply the correct blank.
paulh4

This is where I obtained mine from - pressed lettering from below with the correct rivet fixings.


http://www.minimail.co.uk/chassis-vin-plates/

richard boobier

Thank you, I now know where to have a new plate made and stamped.

A remaining challenge will be to remove the old rivets in the engine block. Are they soft aluminium or steel? I had hoped to drill them out if possible.

Regards,

Jan
Jan Emil Kristoffersen

They are hardened steel and you need to try and unscrew them, if possible.

I use a small chisel and tap gently to unscrew them anti-clockwise.

If they break - which they sometimes do - it's unlikely that you will drill them out, although you can always re-drill the holes in another position.
Dave O'Neill 2

This thread was discussed between 07/11/2016 and 12/11/2016

MG MGB Technical index

This thread is from the archives. Join the live MG MGB Technical BBS now