Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGF Technical - Have you had it off yet?
| I posted a report on spare wheel/rusting bolt ect.20/8. Has any one had this problem? Paul... |
| PAUL. HINDLE. |
| No - I remove my spare regularly anyway, but the service agents, Swain and Jones grease the threads so this never becomes a problem. |
| Rob Bell |
| >No - I remove my spare regularly anyway me too :-( |
| Will Munns |
| Rob. If I am the only on I would be very surprized. Paul... |
| PAUL. HINDLE. |
| Yes, I agree Paul - a good heads up. Not all MGR dealers are as good as the ones I've used in the past (Sewards nr Bournemouth and Swain and Jones in Farnham). |
| Rob Bell |
| Paul, Found that mine was beginning to rust (2001 VVC) when I had a blow-out a couple of months ago, so I greased the threads when I got home! Chris |
| Chris |
| In a similar area, I found that I could not remove my front wheels with car only about 6 months old due to the corrosion between the alloys and the wheel. When I finally did get them off I used Copper grease to ensure the problem did not occur again. Good job I didn't have a puncture. |
| Steve |
| >have you had it off yet?< just reminds me, must join a singles club or something, i wonder how many single ladies on here,mmn could start the mgf lonely hearts club,PAUL this is all your fault ha !,think id'e better go walk the dog.Dave. |
| david morris |
| David. Keep taking the tablets!!! |
| PAUL. HINDLE. |
| Ha Ha,ok. |
| david morris |
| Paul, how old is the car ? A well known problem at early MGF in any way. There was an official bulletin, I think already in 1997. They forgot to grease the bolt. Should be done by factory since that time. Dieter |
| Dieter |
| Dieter. My car is a T reg. 1.8vvc. Paul... |
| PAUL. HINDLE. |
This thread was discussed on 22/08/2002
MG MGF Technical index
This thread is from the archives. Join the live MG MGF Technical BBS now