Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
|
|
MG TD TF 1500 - Can engine and transmission be install as a unit?
| Trying to get my engine back in the car. (GOF is in 4 days). Spent 4 hours last night and could not get the first motion shaft in the pilot. I am going to pull the transmission out and mate them on the floor to see whats going on. Checked the pilot bushing ID - twice, reset the fiber clutch plate twice. So once I do get it together, is there enough room to go back in mated? I seem to remember a thread, but cannot locate it. I have set the transmission in with the engine in place, so I think I might go that route, by setting the engine in, then installing the transmission from the top. Blair |
| Blair Weiss |
| I always pull and install the engines back in with the transmission attached. Pull the gearshift lever out first. PJ |
| Paul S Jennings |
| U can do that. I have done it before in a TD. |
| Tom Maine |
| Thanks Paul, I just needed to know that geometrically it can be done. It's in now... Looks like we just might make the GOF. Blair
|
| Blair Weiss |
| Oh my!! supercharged and all that jazz! Jud |
| J K Chapin |
| Supercharged and a Len Fenelli cam :) |
| Blair Weiss |
| Zoom! Zoom! |
| D. Sander |
This thread was discussed between 15/06/2014 and 16/06/2014
MG TD TF 1500 index
This thread is from the archives. Join the live MG TD TF 1500 BBS now