Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG TD TF 1500 - Holes bottom and backside toolbox TF
| There are some holes in my toolbox I don't know the purpose from. They seems to be original but not sure. Is the one in the middle for a cable clip for the wiring harness under the dash? What about the two on the left hand side?
|
| John van den Boorn |
Here are the holes in the backside. The four which are grouped on the right hand side are also there on the left hand side... a left over from the TD?
|
| John van den Boorn |
| Or even earlier.. Cheers Peter TD 5801 |
| P Hehir |
| Same question comes up every few years. Apparently, it is one of the mysteries of life and nobody has a definitive answer (as far as I know). |
| WHTroyer |
| The two on the left are probably for the wooden block which stops the jack from sliding about. I'm guessing the centre one is for a drain but don't know if the factory did it. Attached a pic I found of my car. Matthew.
|
| M Magilton |
| John, I have some holes in my tool box that hold a plate that supports the Smiths Heater. I have had two TD's and both had the same round Smiths heater nstalled when I got them. Rod
|
| Rod Jones |
This thread was discussed between 21/10/2017 and 23/10/2017
MG TD TF 1500 index
This thread is from the archives. Join the live MG TD TF 1500 BBS now