Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
|
MG TD TF 1500 - TF underdash cover
I am ready to install the under dash cover on my TF and wondered if anyone can tell me where the spacers are used. Four came with the cover and assume they are used on the four inner holes. Can't find anything in the archive covering this. BB ![]() |
R Brown |
Hi BB, I'm not an expert on this cover, since most of us don't fit them even if we have them! However the 'spacers' in your picture must have been added in the past to fit some unknown (to me)accessory, and are not original or needed to fit the cover, which uses cup washers and screws in the pre - drilled holes. Hope this helps, Cheers, John |
J C Mitchell |
No need for spacers but you should have screw eyelets to support the cover. Matthew. ![]() |
M Magilton |
Thanks guys, I'll go without the spacers which should make the process easier. BB |
R Brown |
BB any chance you could trace the cover before you install it? thanks |
RG Taylor |
Sorry too late. If I have to remove it again I will make a copy |
R Brown |
This thread was discussed between 06/12/2014 and 07/12/2014
MG TD TF 1500 index
This thread is from the archives. Join the live MG TD TF 1500 BBS now